Extract 10 1L
Video review
Amount
Purpose: for the cleaning of textile coverings that are resistant to wetting (carpets, upholstery of upholstered furniture, floor carpets, curtains) by means of extraction, including hot extraction.
Solution preparation: mix Extract 10 concentrate with clean water in a ratio of 1:50 - 1:100 (100-200 ml per 10 litres of water). 25-50 g of Cleaner Powder per 10 litres of Extract 10 solution or 50-100 ml of Despotter concentrate per 10 litres of Extract 10 solution can be added to increase the cleaning power.
Application: pour the solution into the detergent extractor tank, clean the surface, and at the same time supply and collect the solution with the extractor (vacuum cleaner). Use a stronger solution or pre-wet with Despotter for very dirty surfaces.
Do not rinse after cleaning commercial floor coverings that have been cleaned with Extract 10 solution without pre-treatment or with Cleaner Powder only.
Furniture upholstery and carpets used in the home should always be rinsed with Acid Cleaner solutions according to the instructions after cleaning with Extract 10.
Warning: Before application, conduct a color fastness test on the surface to be cleaned. Avoid prolonged contact with marble surfaces. Do not ingest. Prevent contact with the eyes' mucous membranes. If contact occurs, rinse thoroughly with plenty of water. If swallowed, rinse the mouth, do not induce vomiting, and seek medical attention. It is recommended to use rubber gloves, aerosol masks, and protective eyewear during application. Keep out of reach of children.
Storage conditions: Store in a tightly closed container at temperatures ranging from 5°C to 40°C in a vertical position, away from heat sources, open flames, sunlight, and atmospheric precipitation.
Composition: demineralized water, non-ionic surfactants 5-15%, cationic surfactants less than 5%, chelating agents.
pH of concentrate: 13.
pH of the prepared solution: 10.
Application: pour the solution into the detergent extractor tank, clean the surface, and at the same time supply and collect the solution with the extractor (vacuum cleaner). Use a stronger solution or pre-wet with Despotter for very dirty surfaces.
Do not rinse after cleaning commercial floor coverings that have been cleaned with Extract 10 solution without pre-treatment or with Cleaner Powder only.
Furniture upholstery and carpets used in the home should always be rinsed with Acid Cleaner solutions according to the instructions after cleaning with Extract 10.
