Acidic Cleaner Aromacid Grapefruit Aroma 1L
Amount
Purpose: Aromacid solution is used for delicate cleaning, finishing of textile coatings resistant to wetting, neutralisation of residual odours of urine, perspiration, mould, rot and tobacco smoke.
Solution preparation:
For delicate cleaning and post-cleaning of textile coatings: 1:9-10 concentrate/water.
To neutralise residual odours: 1:5-1:10 concentrate / water.
Application:
Delicate cleaning and post-cleaning: use a vacuum cleaner to thoroughly rinse the surface of the product with Aromacid solution. The rest of the solution can be left on the textile coating.
Odour neutralisation: perform a general cleaning of the area to remove the bulk of the stain, pour excess Aromacid solution over the treated area so that it soaks in deeper than the stain, wait 5-10 minutes, then carefully collect with an extractor and refill with a new solution with a concentration of 1:9-10, wait 5-10
minutes and collect the excess Aromacid solution. A small amount of Aromacid solution will allow you to achieve high quality odour neutralisation.
Warning: It is mandatory to conduct a preliminary test for the colorfastness of the product subject to cleaning. Avoid contact of the product with marble surfaces. Do not allow contact with eyes or ingestion. If contact with eyes occurs, rinse with plenty of water. It is recommended to use rubber gloves, anti-aerosol masks, and protective goggles.
Please note that leaving a large amount of Aromacid in the product may lead to the formation of efflorescence on the surface during drying. In such a case, any formed efflorescence should be rinsed off with clean water, and the surface should be dried again.
Storage conditions: Store in tightly closed original packaging, in a place inaccessible to children, at a temperature ranging from 5 to 40°C in a vertical position, away from heat sources, open flames, sunlight, and atmospheric precipitation.
Composition: demineralized water, cationic surfactant from 5% to 15%, absorbent, fragrance, organic acid.
pH concentration: 2.5.
pH of 9% solution: 3.7-4.3.
Application:
Delicate cleaning and post-cleaning: use a vacuum cleaner to thoroughly rinse the surface of the product with Aromacid solution. The rest of the solution can be left on the textile coating.
Odour neutralisation: perform a general cleaning of the area to remove the bulk of the stain, pour excess Aromacid solution over the treated area so that it soaks in deeper than the stain, wait 5-10 minutes, then carefully collect with an extractor and refill with a new solution with a concentration of 1:9-10, wait 5-10
minutes and collect the excess Aromacid solution. A small amount of Aromacid solution will allow you to achieve high quality odour neutralisation.
